Adjusting Throttle Position (TP) sensor

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Only vehicles with adjustable throttle position sensor

Work procedure

Adjust cable pulley:

Fig 1: Identifying Throttle Position Sensor Cable Pulley

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Install cable pulley in indicated position.
Fasten throttle position sensor with the pre-installed cable pulley to mounting bracket.
Connect 6-pin harness connector to sensor.

Fine tuning the sensor in installed condition:

Depress accelerator pedal by hand until the accelerator pedal is fully depressed against the stop.

NOTE:

On vehicles with automatic transmission, the pressure point of the kick-down switch must be noticeable before the throttle reaches the wide open stop.

If accelerator pedal stop is not reached and pressure point of the kick down switch is not noticed: Turn sensor in the slots of the mounting bracket.

After adjusting sensor, use scan tool V.A.G 1551 or mobile scan tool V.A.G 1552 and cable V.A.G 1551/3. Refer to Throttle position (TP) sensor, checking to check the throttle position sensor.