Part I
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Part II Oil filter bracket, assembly overview
Part III Oil supply line, removing and installing
1 - 15 Nm
2 - Bracket
- For wiring harness of oil level thermal sensor
- Multiple versions: Bolted or clipped
3 - 15 Nm
4 - Oil dipstick
- Oil level must not be above Max. mark!
- Marks Markings on oil dipstick
5 - Inlet spout
- For extracting oil
6 - Guide tube
7 - Alignment bushings
8 - O-ring
- Always replace
9 - 15 Nm
10 - Suction line
- Clean strainer if dirty
11 - Splash wall
12 - 15 Nm
13 - 15 Nm
14 - Oil pan
- Clean sealing surface before installing
- Install with silicone sealant D 176 404 A2 . Refer to Oil pan, removing and installing
15 - Oil seal
- Always replace
16 - Oil drain plug, 30 Nm
- Replace screw with permanent sealing ring
17 - 10 Nm
18 - Oil level thermal sensor G266
- Only on vehicles 05.99 →
- Check. Refer to Electrical Wiring Diagrams, Troubleshooting and Component Locations
19 - Oil seal
- Always replace
20 - Oil pump
- With pressure relief valve 12 bar
- Before installing, check to be sure both alignment bushings are present (for centering oil pump/cylinder block)
- Replace if contact surfaces and gears are scored
21 - Chain sprocket
22 - 20 Nm
23 - 15 Nm
24 - Chain
25 - Sealing flange
- With seal
- Removing and installing. Refer to Sealing flange (front), removing and installing
- Install with silicone sealant D 176 404 A2 . Refer to Sealing flange (front), removing and installing
- Note different versions of seals
- PTFE-version of sealing ring without internal ring spring
- Seal for crankshaft - belt pulley side, replacing. Refer to Crankshaft seal (ribbed belt side), replacing
26 - Chain tensioner with tensioning rail, 15 Nm
- When installing, pretension spring and engage