Engine, securing to assembly stand
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- To work on the engine outside of the vehicle, secure engine to assembly stand using holding fixture VW 540 on holding fixture VW 313.
Work procedure
- Remove transmission from engine.
Vehicles with automatic transmission
- Secure torque converter to prevent it from "falling out" after engine and transmission are separated.
All vehicles
- Attach engine sling 2024 A as follows and lift engine from engine/transmission jack V.A.G 1383 A using workshop crane.
Belt pulley side: 2nd hole in hook at position 2
Flywheel side: 3rd hole in hook at position 8
CAUTION:
Secure ALL hooks and locating pins with lock pins!
NOTE:
- Positions marked 1 to 4 on the bar must be located toward the pulley end of the engine.
- The holes in the hooks are counted up from the hook.
- Fasten engine using holding fixture VW 540 to holding fixture VW 313.