EVAP canister system, assembly overview
WARNING: This page is about a different car, the 2004 Volkswagen R32. However, it is still accessible from the selected car via links, so may be relevant.
1 - Hose clamp
2 - Connecting hose
- For breather lines
3 - Vent line
- Connected to EVAP canister
4 - Connector
- Black, 2-pin
- For Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115
5 - Bolt
6 - Filter housing
- For Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115
7 - Evaporative emission (EVAP) canister purge solenoid valve N115
8 - Filter element
- For Evaporative Emission (EVAP) Canister Purge Solenoid Valve N115
9 - EVAP canister
- Removing and installing, refer to Leak detection pump and EVAP canister, removing and installing
10 - 23 Nm
11 - Cover
12 - 8 Nm
13 - Vent line
- From the Leak Detection Pump (LDP) V144 to Evaporative Emission (EVAP) Canister Purge Regulator Valve N80
- Clipped in wheelhousing
14 - Separating point
- For breather line
- To separate, press together front release button
15 - Reservoir
16 - Trim strip
- Secured in wheelhousing
17 - 15 Nm
18 - To leak detection pump (LDP) V144
- Ensure seated tightly
19 - Vent line
- For fuel tank
- Ensure seated tightly
20 - Gasket