Installation sequence

WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Removing

Fig 1: View Of Oil Lines

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove sound insulation.
Position drip tray V.A.G 1306 underneath.
Remove air cleaner housing.
Remove union nut - 2 - or banjo bolt - 4 - from oil filter bracket.
Remove bolt - 6 -.
Remove union nut - 2 - on turbocharger.
Remove bolt - 9 - from bracket - 7 -.
Remove nut - 8 - and take off bracket - 7 -.
Remove oil supply line - 1 -.

Installing

Installation is performed in reverse order of removal. Note the following:

CAUTION: The installation of the oil supply line must be as described below.

Screw bracket - 7 - with nut - 8 - loosely to exhaust manifold.
Install union nut - 2 - or banjo bolt - 4 - on oil filter bracket.
Install union nut - 2 - on turbocharger.
Tighten union nut - 2 - or banjo bolt - 4 - on oil filter bracket to specified torque.
Tighten union nut - 2 - on turbocharger to specified torque.
Position clips - 5 - on oil supply line.
Tighten bolts - 6 - and - 9 - to specified torque.
Tighten nut - 8 - to specified torque.