Work sequence
WARNING: This page is about a different car, the 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, 2004 Volkswagen Jetta, and 2004 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
Piston projection of all pistons at TDC must be measured when installing new pistons or a short engine. Depending upon piston projection, install the corresponding cylinder head gasket according to the following table:
NOTE:
- Turn engine clockwise to measure piston projection at TDC.
| Piston projection | Gasket Identification Holes/notches |
| 0.91 mm to 1.00 mm | 1 |
| 1.01 mm to 1.10 mm | 2 |
| 1.11 mm to 1.20 mm | 3 |