Diagnostic mode 7: Check test results of components that are continuously monitored: Procedure

WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen Jetta, 2004 Volkswagen Jetta, 2003 Volkswagen Jetta, 2003 Volkswagen Golf, and 2002 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Connect diagnostic tester, see CONNECT DIAGNOSTIC TESTER .
Start engine and let run at idle.
NOTE:
Only if engine does not start:
- Operate starter for approx. 6 seconds. Do not switch ignition off afterward.
Under address word 33, select "Diagnostic mode 7: Check test results of components that are continuously monitored".

The number of stored malfunctions or "0 malfunctions detected" is displayed.

End diagnosis and switch ignition off.
Repair stored malfunctions according to DTC table:

SAE P0xxx-DTCs, see DIAGNOSTIC TROUBLE CODE (DTC) TABLES: ,
SAE P1xxx-DTCs, see SAE P1XXX-DTCS ,
SAE P2xxx-DTCs, see SAE P2XXX-DTCS .

NOTE:

The DTC table is sorted by SAE code.
"E-Gas"-relevant malfunctions are also indicated by the warning lamp for Electronic Power Control ("EPC warning lamp") in the instrument cluster.
Erase DTC memory after repairing malfunction, see DIAGNOSTIC MODE 4: RESET/ERASE DIAGNOSTIC DATA .