Diagnostic mode 2: Checking operating conditions: Procedure: Notes
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen Jetta, 2004 Volkswagen Jetta, 2003 Volkswagen Jetta, 2003 Volkswagen Golf, and 2002 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Connect diagnostic tester, see CONNECT DIAGNOSTIC TESTER .
- Depending on the desired operating condition: switch on ignition or Start engine and let run at idle.
- Under address word 33, select "Diagnostic mode 2: Check operating conditions."
- Select the desired operating condition "PID XX".
NOTE:
The operating conditions are sorted by the PID (parameter-identifications).
DIAGNOSTIC MODE 2: PID IDENTIFICATION
| PID | Display operating conditions |
|---|---|
| 02: | DTC which triggered the current reception of all control module information
|
| 03: | Condition of the fuel system |
| 04: | Calculated load condition value |
| 05: | Coolant temperature |
| 06: | Short time gasoline -air ratio bank 1 |
| 07: | Gasoline-air ratio bank 1 |
| 12: | Engine rotations per minute (RPM) |
| 13: | Vehicle speed |