Connect diagnostic tester: Procedure
WARNING: This page does not describe the selected car, but rather 14 other vehicles, including the 2005 Volkswagen Jetta, 2004 Volkswagen Jetta, 2003 Volkswagen Jetta, 2003 Volkswagen Golf, and 2002 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Connect diagnostic tester (VAS 5052) using (VAS 5052/3) diagnostic cable as follows:
- Connect diagnostic cable connector to Data Link Connector (DLC) -arrow-.
- Depending on the desired diagnostic mode, it is necessary to: switch on ignition or start engine, see CONNECT DIAGNOSTIC TESTER , selectable diagnostic modes under address word 33.
NOTE:
- Respective operation of the diagnostic tester:
See Operating instructions of the diagnostic tester
- If no display appears on diagnostic tester, check voltage supply at Diagnostic Link Connector (DLC).