Parking lock
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
See READ MEASURING VALUE BLOCK (FUNCTION 08)
.
- Output gear must be removed to disassemble and assemble parking lock, see DRIVE PINION, REMOVING AND INSTALLING .
The following list pertains to Fig 1.
- Bolt
- 4 N.m (35 in lb)
- Manual selector valve control
- Adjusting, see VALVE BODY, REMOVING AND INSTALLING
- Selector shaft with selector segment
- Removing and installing, see Selector shaft with selector segments, removing and installing
- Spring pin
- Driving out and in, see Spring pin -arrows-, removing and installing
- Engaging lever
- Install together with selector shaft and detent segment
- Detent segment
- Install together with selector shaft and engaging lever
- Lock washer
- Bolt
- 10 N.m (7 ft lb)
- Spring for selector segment
- Bolt
- 10 N.m (7 ft lb)
- O-ring
- Always replace
- Only install on shafts with groove for circlip
- Washer
- Shaft for detent lever
- Secured by circlip and bearing cap of drive pinion
- Return spring
- Inserting, see Pawl with return spring, installing
- Detent lever
- Installing with return spring, see Pawl with return spring, installing
- Parking lock gear
- Rounded side faces teeth of drive pinion
- Bolt
- 14 N.m (10 ft lb)
- Supporting plate
- Installing, see Guide plate and supporting plate, installing
- Guide plate
- Install before supporting plate, see Guide plate and supporting plate, installing
- O-ring
- Always replace
- Multi-function Transmission Range (TR) Switch -F125-
- Install so that 1 pin each is resting on a slope of detent segment
- Test in vehicle with On Board Diagnosis (OBD)
- Retainer
- For multi-function switch
- Bolt
- 10 N.m (7 ft lb)
- Transmission housing
- It is not necessary to remove drive gear to disassemble parking lock
- O-ring
- Always replace
- Vehicle Speed Sensor (VSS) -G68-
- Test in vehicle with On Board Diagnosis (OBD)
- Bolt
- 10 N.m (7 ft lb)
- Bolt
- 10 N.m (7 ft lb)
- Transmission Vehicle Speed Sensor (VSS) -G38-
- Test in vehicle with On Board Diagnosis (OBD)
- O-ring
- Always replace
- O-ring
- Pry out with screwdriver
- Drive in flush with VW 423
- Breather pipe
- Remove using pliers
- Drive onto stop with drift VW 460/2
- Breather
- Breather cap