Transmission, removing and installing: Installing

WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in the reverse order.

When installing the torque converter, ensure that both drive pins engage in the ATF pump inner wheel recesses.

Before installing, ensure the dowel sleeves are correctly located.
When installing transmission, observe torque converter contact impression on drive plate.

Replace selector cable anchorage locking washer.
Check selector lever cable adjustment, adjust if necessary, see SELECTOR LEVER CABLE, CHECKING AND ADJUSTING .