III - Free wheel and reverse gear brake -B1-, removing and installing
WARNING: This page does not describe the selected car, but rather 25 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.
For an overview, TRANSMISSION, DISASSEMBLING AND ASSEMBLING, OVERVIEW
NOTE:
- Transmission, disassembling, see TRANSMISSION, DISASSEMBLING
- Transmission, assembling, see TRANSMISSION, ASSEMBLING .
The following list pertains to Fig 1.
- Circlip
- For supporting tube -B2-
- Installation position: Circlip open ends must face free wheel retaining wedge
- Circlip
- For free wheel
- Installation position: Circlip open ends must face free wheel retaining wedge
- Free wheel with -B1- piston
- Before removing free wheel, remove valve body and sealing plugs, see VALVE BODY, REMOVING AND INSTALLING
- Disassembling and assembling, see FREE WHEEL WITH -B1- PISTON, DISASSEMBLING AND ASSEMBLING
- Dished spring
- Install with convex side facing free wheel
- Pressure plate -B1-
- Install with flat side facing plates
- Spare part must comply with transmission code letters
- Inner plate, -B1-
- Quantity of inner plates -B1-, see TRANSMISSION LAYOUT
- Soak plates in ATF for 15 minutes before installing
- Outer plate, -B1-
- Quantity of outer plates -B1-, see TRANSMISSION LAYOUT
- Shim
- Determining thickness, see REVERSE GEAR BRAKE -B1-, ADJUSTING , adjusting reverse gear brake -B1-
- Transmission housing with planet carrier installed