Read Measuring Value Block (function 08)

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

The measured value block is divided into 2 display group numbers. The assignment of the individual display fields can be taken from the display group overview. See DISPLAY GROUP OVERVIEW .

After displaying the control module identification:

Press --> button.

Indicated on display:

Fig 1: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Function 08) (Rapid Data Transfer)

G03364065

Courtesy of VOLKSWAGEN OF AMERICA, INC.

Press buttons -0- and -8- (08 initiates the "Read measured value block" function).

Indicated on display:

Fig 2: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Function 08) (08 Read Measured Value Block)

G03364066

Courtesy of VOLKSWAGEN OF AMERICA, INC.

Confirm entry with the -Q- button.

Indicated on display:

Fig 3: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Function 08) (Enter Display Group Number)

G03364067

Courtesy of VOLKSWAGEN OF AMERICA, INC.

The display group number 001 is an example, to illustrate the sequence.

Press buttons -0-, -0- and -1- for "Display group number 1" and confirm entry with -Q- button.

Indicated on display: (1...4 Display fields)

Fig 4: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Function 08) (Rear Measured Value Block 1)

G03364068

Courtesy of VOLKSWAGEN OF AMERICA, INC.

NOTE: To change to another display group proceed as follows:

Fig 5: Display Group Chart

G03364069

Courtesy of VOLKSWAGEN OF AMERICA, INC.

Displayed after pressing -C- button.

Indicated on display:

Fig 6: Identifying VAG 1551 Scan Tool Display (Cabrio Up To May 1999 - Function 08) (Enter Display Group Number)

G03364070

Courtesy of VOLKSWAGEN OF AMERICA, INC.

Enter display group number required.

NOTE: Condition of immobilizer at the point when ignition was switched on will always be shown via measured value block. If an electrical malfunction occurs which changes this condition after ignition is switched on, it will not be displayed until ignition is switched on again and "Read measured value block" is selected.