Airbag unit, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 27 other vehicles, including the 2002 Volkswagen Cabrio, 2001 Volkswagen Cabrio, 2000 Volkswagen Cabrio, 1999 Volkswagen Jetta, and 1999 Volkswagen Golf. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect battery Ground (GND) strap.
Center steering wheel (straight-ahead position).
Remove both socket head screws for airbag unit (some versions may use clips).
- Always replace
- Tightening torque: 6.5 N.m (58 in lb)
Fig 1: Removing Both Socket Head Screws For Airbag Unit
Courtesy of VOLKSWAGEN OF AMERICA, INC.
Remove airbag unit from steering wheel and disconnect wiring harness connector from airbag unit.