Transmission Control Module J217, Replacing: Installation
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in the reverse order of removal. note the following:
- Check the identification of the new Transmission Control Module (TCM) J217 to ensure it matches the old Transmission Control Module (TCM) J217.
- Code the Transmission Control Module (TCM) J217.
- Erase the DTC memory. Refer to DIAGNOSTIC MODE 04: RESET/DELETE DIAGNOSTIC DATA .
- Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to READINESS CODE, GENERATING .
- End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was OK:
- Replace the Motronic Engine Control Module (ECM) J220. Refer to REPLACING ENGINE CONTROL MODULE (ECM) .
- Assembly is performed in the reverse of the removal.