Checking resistance
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Using a multimeter , check the Solenoid Valve terminals 1 to 2 at the Solenoid Valve electrical harness connector for resistance.
| Solenoid Valve | Electrical Harness Connector Terminal | Specified Value (Approx. 20 ° C) |
|---|---|---|
| Solenoid Valve 1 N88 | 1 to Ground (GND) | 10.0 - 16.0 Ω |
| Solenoid Valve 2 N89 | 2 to Ground (GND) | 10.0 - 16.0 Ω |
| Solenoid Valve 3 N90 | 7 to 8 | 4.0 - 8.0 Ω |
| Solenoid Valve 4 N91 | 11 to 12 | 4.0 - 8.0 Ω |
| Solenoid Valve 5 N92 | 3 to 4 | 4.0 - 8.0 Ω |
| Solenoid Valve 6 N93 | 13 to 14 | 4.0 - 8.0 Ω |
| Solenoid Valve 7 N94 | 5 to 6 | 4.0 - 8.0 Ω |
If the specification was not obtained:
- Replace the faulty Solenoid Valve . Refer to Automatic Transmission - Repair Group 37.
If the specified values are obtained: