III - Freewheel and reverse gear brake -B1-, removing and installing

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Freewheel And Reverse Gear Brake -B1- Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Refer to Overview, Planetary gearbox, disassembling and assembling -Overview- .
Disassembling planetary gearbox. Refer to Planetary gearbox, disassembling and assembling .
Assembling. Refer to Assembling planetary gearbox .

1 - Circlip

For supporting tube -B2-
Installed position: Circlip open ends face freewheel retaining wedge

2 - Circlip

For freewheel
Installed position: Circlip open ends face free wheel retaining wedge

Fig 2: View Of Freewheel And Reverse Gear Brake -B1- Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

3 - Freewheel with -B1- piston

Before removing freewheel, remove valve body and sealing plugs. Refer to Valve body, removing and installing
Disassembling and assembling. Refer to Freewheel with -B1- piston, disassembling and assembling

4 - Dished spring

Install with convex facing freewheel

5 - Pressure plate -B1-

Install with flat side facing plates
Spare part is determined according to transmission code letters

6 - Inner plate, -B1-

Quantity of inner plates -B1-. Refer to Code letters, application, ratios, equipment
Before installing place plates in ATF for 15 minutes

7 - Outer plate, -B1-

Quantity of outer plates -B1-. Refer to Code letters, application, ratios, equipment

8 - Shim

Determining thickness. Refer to Reverse gear brake -B1-, adjusting , adjusting reverse gear brake -B1-

9 - Transmission housing with planet carrier installed