I - ATF pump to supporting tube, removing and installing

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of ATF Pump To Supporting Tube Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

NOTE:

Refer to Overview, Planetary gearbox, disassembling and assembling -Overview- .
Disassembling planetary gearbox. Refer to Planetary gearbox, disassembling and assembling .
Assembling. Refer to Assembling planetary gearbox .

1 - Bolt

Qty. 7
Tighten to 8 Nm and turn 90 ° further
Turning further of 90 ° may be done in several stages

2 - ATF pump with -B2- piston

Spare part is determined according to transmission code letters
Disassembling and assembling. Refer to ATF pump, disassembling and assembling

3 - O-ring

Always replace
Place on ATF pump

Fig 2: View Of ATF Pump To Supporting Tube Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

4 - Gasket

Always replace

5 - Spring cap, Qty. 6

Install 3 spring caps after installing first outer plate
Install 3 spring caps before installing last outer plate

6 - Spring

Qty. 3

7 - Retaining ring

8 - Shim

9 - Outer plate -B2-

3 mm thick

10 - Inner plate -B2-

Quantity. Refer to Code letters, application, ratios, equipment
Before installing place new inner plates in ATF for 15 minutes

11 - Outer plate -B2-

Always install 2 mm thick outer plates
Quantity. Refer to Code letters, application, ratios, equipment

12 - Outer plate -B2-

Fit 3 mm thick outer plate to supporting tube

13 - Supporting tube -B2-

For -B2- plate package
Spare part is determined according to transmission code letters
Insert so that groove engages in wedge of freewheel

14 - Transmission housing with clutches installed

15 - Strainer

Not installed until transmission manufacture date 14 02 0.