Basic setting, initiating
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2007 Volkswagen Golf, 2006 Volkswagen Golf, 2005 Volkswagen Jetta, 2005 Volkswagen Golf, and 2004 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Initiate the basic setting after performing the following repairs:
- Engine replacement
- Engine control module replacement
- Replacing/altering throttle valve (setting idling speed)
- Throttle Position (TP) Sensor -G69- replacement
- TP Sensor -G69- setting alteration, e.g. when adjusting Closed Throttle Position (CTP) Switch (engine)
- Transmission Control Module -J217- replacement
- Connect VAG 1551 Scan Tool and enter address word "02 Transmission electronics". Advance until "Select function XX" appears in the display. Refer to VAG 1551 Scan Tool, connecting and selecting functions .
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press buttons -0- and -4- to select "Initiating basic setting" function 04.
NOTE:
The accelerator pedal must remain in idling position.
Indicated on display
| Rapid data transfer Q 04 - Basic setting |
- Confirm entry with -Q- button.
Indicated on display
| Basic setting HELP Enter display group number XXX |
- Press buttons -0-, -0- and -0-.
- Confirm entry with -Q- button.
Indicated on display
| System in basic setting 0 → |
The system is now in basic setting.
- Depress accelerator pedal as far as kickdown and hold in this position for 3 seconds.
- Press → button.
Indicated on display
| Rapid data transfer HELP Select function XX |