Work sequence
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Volkswagen Jetta, 2002 Volkswagen GTI, 2001 Volkswagen Jetta, 2001 Volkswagen GTI, and 2000 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Connect Scan Tool (ST) VAG 1551.
- Press buttons - 0 - and - 1 - to insert "Engine Electronics" address word 01. Engine must be running at idle (connecting scan tool and selecting engine electronics control module → Scan Tool (ST) VAG 1551 , connecting and selecting functions ).
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 8 - to select "Read Measuring Value Block" function 08.
Indicated on display
| Read Measuring Value Block Input display group number XXX |
- Select required display group number.
NOTE:
- The display group number 0 is used as an example to illustrate the sequence.
- Press buttons - 0 - , - 0 - and - 0 - to input display group number 00 - 000 - and press - Q - button to confirm input.
Indicated on display (1-10 = display fields)
| Read Measuring Value Block 0 -> 1 2 3 4 5 6 7 8 9 10 |
NOTE:
- To change to another display group proceed as follows:
| Display group | Scan Tool (ST) VAG 1551 | Scan Tool (ST) VAG 1552 |
| Higher | Press button - 3 - | Press ↑ button |
| Lower | Press button - 1 - | Press ↓ button |
| Skip | Press button - C - | Press button - C - |
- If specifications in all display fields are obtained, press → button.
- If one of the specifications is not obtained.
Additional measures → repair procedures.
Indicated on display
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 6 - to select "End output" function 06 and press - Q - button to confirm input.
- Switch ignition off.