Work sequence
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Volkswagen Jetta, 2001 Volkswagen Golf, 2000 Volkswagen Jetta, 2000 Volkswagen Golf, and 1999 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- With engine at idle connect Scan Tool (ST) V.A.G 1551 / V.A.G 1552 and select Engine Control Module (ECM) with "Address word" 01. → Scan Tool V.A.G 1551 , connecting , V.A.G 1551 Scan Tool, connecting.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 8 - for "Read measuring value block" and confirm with - Q - button.
Indicated on display:
| Read measuring value block HELP Input display group number XXX |
- Select display group number.
NOTE:
- Display group number - 0 - is an example, to illustrate sequence.
- Press buttons - 0 - , - 0 - and - 0 - for "Display group number -0-" and confirm with - Q - button.
Indicated on display:
| Read measuring value block 0 -> 1 2 3 4 5 6 7 8 9 10 |
(1...10 = Display zones)
NOTE:
- To change to another display group proceed as follows:
| Display group | V.A.G 1551 | V.A.G 1552 |
| Higher | Press button 3 | Press ↑ button |
| Lower | Press button 1 | Press ↓ button |
| Skip | Press button C | Press button C |
- If specifications in all display zones are obtained, press → button.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons - 0 - and - 6 - for "End output" and confirm with - Q - button.
- Switch off ignition.