Ignition system components, removing and installing
WARNING: This page is about a different car, the 2001 Volkswagen Jetta, 2001 Volkswagen Golf, 2000 Volkswagen Jetta, 2000 Volkswagen Golf, and 2000 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
1 - Connector
- Black, 4 pin
2 - 10 Nm
3 - Ignition coil with output stage -N70-, -N127-, -N291-, -N292-
- Checking. Refer to Ignition coils with output stage, checking
4 - Spark plug, 30 Nm
- Remove and install with 3122B
- Type and electrode gap. Refer to Test data, spark plugs , test data, spark plugs
5 - 3-pin connector
- Contacts gold plated
- Brown for Knock sensor (KS) 1 -G61-
- Black for Knock sensor (KS) 2 -G66-
6 - 20 Nm
- Tightening torque influences the function of the knock sensor
7 - Knock sensor (KS) 1 -G61-*
- Sensor and connector contacts are gold-plated
- Checking. Refer to Knock sensors, checking
8 - Knock sensor (KS) 2 -G66-*
- Sensor and connector contacts are gold-plated
- Checking. Refer to Knock sensors, checking
9 - Connector
- Black, 3-pin
10 - 10 Nm
11 - Camshaft Position (CMP) sensor 2 -G163-*
- Checking. Refer to Camshaft Position (CMP) sensor 2 -G163-, checking
12 - 25 Nm
13 - Washer
- Conical
14 - Hood
- For Camshaft Position (CMP) sensor 2 -G163-
- When installing note fixing arrangement
15 - Ground wire
- Only loosen or tighten with ignition switched off
16 - 10 Nm
- Only loosen or tighten with ignition switched off