LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2004 >> GTI VR6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 101 (1.8L - Fuel Injection & Ignition, Engine Code(S): AWD) >> 01 On Board Diagnostic (OBD) >> Measuring value blocks, evaluating, display groups 50-69 (RPM regulation) >> Measuring value blocks, evaluating, display groups 50-69 (RPM regulation) >> Display group 50 -RPM regulation- operating conditions

Display group 50 -RPM regulation- operating conditions

WARNING: This page is about a different car, the 2001 Volkswagen Jetta, 2001 Volkswagen Golf, 2000 Volkswagen Jetta, 2000 Volkswagen Golf, and 2000 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Display group 50 -RPM regulation- operating conditions 
  • Engine running at idle
Read Measuring Value Block 50 ← Indicated on display:    
xxxx/min xxxx/min Text Text      
1 2 3 4 ← Display fields Specified value Evaluation
        Operating condition of A/C compressor ON/OFF Compr. ON or
Compr. OFF
---
      Operating condition A/C system A/C-high or
A/C-low
---
    Engine speed (specified value-idle speed):
Manual transmission
Automatic transmission
760 RPM
700 RPM
---
  Engine speed (idle speed)
Manual transmission
Automatic transmission
700 to 820 RPM
640 to 760 RPM
Refer to Evaluation display group 1, display field 1 - engine speed (idle speed) 

Note for display field 2: 

The specified engine speed value determined by the Engine Control Module (internally calculated by the ECM) is displayed. In exceptional cases, the idle speed can be adapted. Refer to  Idle speed, adaptation   . Idle speeds with driving mode engaged are then automatically changed. 

Notes for display field 3: 

Notes for display field 4: