LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2004 >> GTI VR6 >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (4 SPD. Automatic Transmission 096 (A3 Platform)) >> On Board Diagnostic (OBD) >> On Board Diagnostic (OBD), general information >> Basic setting, initiating

Basic setting, initiating

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Volkswagen Jetta III, 1995 Volkswagen Golf III, 1995 Volkswagen Cabrio, 1994 Volkswagen Jetta III, and 1994 Volkswagen Golf III. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The basic setting should be initiated after performing the following repairs:
  • Replacing engine
  • Replacing Engine Control Module (ECM)
  • Replacing or altering throttle valve
  • Adjusting throttle valve (setting idle speed).
  • Replacing Throttle Position (TP) Sensor - G69-
  • Altering setting of Throttle Position (TP) Sensor -G69- (e.g. when adjusting Closed Throttle Position Switch)
  • Replacing Transmission Control Module (TCM) -J217-

Indicated on display:

Fig 1: VAG 1551 Scan Tool Display - Basic Setting (1 Of 5)
G03362604Courtesy of VOLKSWAGEN OF AMERICA, INC.
NOTE: Accelerator Pedal must remain in Closed Throttle Position.

Indicated on display:

Fig 2: VAG 1551 Scan Tool Display - Basic Setting (2 Of 5)
G03362605Courtesy of VOLKSWAGEN OF AMERICA, INC.

Indicated on display:

Fig 3: VAG 1551 Scan Tool Display - Basic Setting (3 Of 5)
G03362606Courtesy of VOLKSWAGEN OF AMERICA, INC.

Indicated on display:

Fig 4: VAG 1551 Scan Tool Display - Basic Setting (4 Of 5)
G03362607Courtesy of VOLKSWAGEN OF AMERICA, INC.

Indicated on display:

Fig 5: VAG 1551 Scan Tool Display - Basic Setting (5 Of 5)
G03362608Courtesy of VOLKSWAGEN OF AMERICA, INC.
scientia non olet · About LEMON Manuals