Gateway, coding (function 07)
When replacing the instrument cluster, the Data Bus On Board Diagnostic Interface -J533- must be coded according to vehicle equipment.
NOTE:
Coding must be performed regardless if the instrument cluster is new or has been previously coded (installed in a vehicle).
Initiating coding
- Press buttons -0- and -7- to select "Code Control Module". function 07.
Indicated on display:
| Rapid data transfer Q 07 - Code control module |
- Press -Q- button to confirm input.
Indicated on display:
| Code Control Module Enter code number XXXXX (0-32000) |
- Determine code number using code table below:
| Control Modules on "Powertrain" CAN Bus | Code: | |
| Automatic transmission | 00001 | |
| Anti-lock brake system (ABS) | 00002 | |
| Airbag | 00004 | |
Code numbers for all control modules connected to the CAN-Bus must be added.
Example:
Airbag + ABS + Autom. transmission: 00004 + 00002 + 00001 = 00007
- Use scan tool button pad to enter code number.
Indicated on display (example only):
| 6N0909901 Gateway K <-> CAN 0001 Coding 00007 WSC 00000 |
- Press -Q- button to confirm input.
Indicated on display:
| Rapid data transfer HELP Select function XX |
- Press buttons -0- and -6- to select "End Output" function 06.
The tester is again in basic function.