Crankshaft Seal, Transmission Side: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Do not additionally lubricate or grease the sealing lip of the seal!

-- Clean the sealing surfaces. They must be free of oil and grease.

-- Before installing, remove any remaining oil from the end of the crankshaft with a clean cloth.

-- Insert the assembly device T10122/1 onto the pull sleeve T10122/2 and slide the seal -A- onto the pull sleeve.

Fig 1: Identifying Seal, Sleeve T10122/1 And Assembly Tool T10122/2

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the assembly device T10122/1.

-- Install the pull sleeve T10122/2 with the seal -A- onto the crankshaft.

Fig 2: Identifying Installation Of Pull Sleeve T10122/2 With Sealing Ring Onto Crankshaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press in the seal all around evenly and flush using the pressure sleeve T10122/3.

The rest of the installation follows the reverse of the removal procedures. When doing this note the following:

Remove the locking pin T40069 from the rear of the cylinder block and install the locking bolt.