Sealing Flange And Drive Plate/Flywheel Overview
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For repairs to the clutch, refer to [For transmission(s) 0A4] Clutch .
- Vibration Damper
- Multiple versions are available.
- Bolt
- 50 Nm + 90° (1/4) additional turn.
- Always replace.
- Only use a strength category 10.9.
- Quantity: 5
- Bolt
- 10 Nm
- Sealing Flange, Belt Pulley Side
- With a integrated seal.
- Removing and installing, refer to SEALING FLANGE, BELT PULLEY SIDE .
- Cylinder Block
- Bolt
- 60 Nm + 90° (1/4) additional turn.
- Always replace.
- Drive Plate/Flywheel
- To remove, lock the crankshaft using the locking pin T40069.
- The flywheel must not be pried off or the timing housing cover will be damaged.
- Drive plate removing and installing, refer to DRIVE PLATE .
- Sensor Wheel
- For the engine speed sensor.
- With position holder.
- Crankshaft Seal, Transmission Side
- Removing and installing, refer to CRANKSHAFT SEAL, TRANSMISSION SIDE .
- Control Housing Cover
- Removing and installing, refer to CONTROL HOUSING COVER .
- O-ring
- Always replace.
- Bolt
- 25 Nm
- Alignment Sleeves
- Bolt
- 5 Nm
- Engine Speed Sensor -G28-
- Seal
- Always replace.