Shift Knob, Boot And Noise Insulation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

Removing

-- Remove the boot with the center console cover from the center console or pry it out carefully -arrows-.

Fig 1: Identifying Shift Boot

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

On some equipment versions, you must pry out the boot at the front area.

-- Fold the boot with the center console cover up over the shift knob.

Fig 2: Identifying Clamp

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Open the clamp -arrow- and remove the shift knob and boot.

In some equipment versions, the center console cover remains in the center console.

-- Pull the center console cover out or pry it out carefully.

-- Remove the noise insulation -1-.

Fig 3: Identifying Noise Insulation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Installing

-- Install the noise insulation.

Fig 4: Identifying Noise Insulation Installation Location

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-Arrow A- points in direction of travel.
The tabs -arrows B- must latch into the center console.

-- Press the center console cover into the center console.

-- Turn the inner side of the boot toward outside.

Install the shift knob all the way on.

-- Install the shift knob with cover and boot and press the new clamp -arrow- together.

Fig 5: Identifying Clamp

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Press the boot and the cover into the center console or press the boot into the cover.