Engine Mount Adjustment, Checking

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

There must be a distance of at least 10 mm -a- between the engine mount bracket and right longitudinal member.

Fig 1: Identifying Casting Edge On Engine Support Location
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
The casting edge on the engine mount bracket -2- must be parallel to the engine mount support arm -1-.

-- If the conditions are not met, then adjust the engine mount. Refer to ENGINE AND TRANSMISSION MOUNT, ADJUSTING .