LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2003 >> Jetta GLI >> Repair and Diagnosis >> External Pages >> Different car >> Section 185 (Gears, Shafts - Manual Transmission 0A4 (Sedan) (A5 Platform)) >> 35 Gears, Shafts >> Disassembly And Assembly >> Output Shaft >> Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside

Assembly: Locking Collar/Synchronizer Hub for 3rd and 4th Gears together with Locking Pieces that are Hollow on the Inside

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Assembling 1St And 2Nd As Well As 3Rd And 4Th Gear Locking Collar/Synchro-Hub
GWWV35-0981Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The locking collar is pushed over the synchronizer hub.

-- Install the locking pieces and springs offset by 120°. The angled end of the spring must engage into the hollow locking piece.

scientia non olet · About LEMON Manuals