Cylinder Head Cover Overview
WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 5 Nm
- Bolt
- 22 Nm
- Protective Strip
- For the fuel rail and high pressure lines.
- Fuel Rail
- With high pressure lines.
- Do not change the angles of the high pressure lines.
- Overview, refer to FUEL RAIL AND INJECTORS OVERVIEW .
- Bolt
- 5 Nm
- Sealing Cap
- Nut
- 10 Nm
- Tensioning Plate
- Always replace.
- Note the installed position, refer to Fig 2.
- Fuel Injector
Overview, refer to FUEL RAIL AND INJECTORS OVERVIEW .
- Bracket
- For the wiring harness.
- Vacuum Hose
- Make sure it is seated correctly and is routed without kinks.
- To the wastegate bypass regulator valve -N75-
- Cylinder Head Cover
- Removing and installing, refer to CYLINDER HEAD COVER .
- Gasket
- Replace if damaged or leaking.
- Bolt
- 10 Nm
- Follow the loosening and tightening sequence, refer to CYLINDER HEAD COVER .
- Cap
- Replace the seal if damaged.
- Heat Shield
- Bushing
- For the fuel rail mounting.
- Replace if damaged.