Control Housing Cover: Removing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
- Engine removed, transmission is disconnected from the flange.
-- Remove the chain compartment cover. Refer to CHAIN COMPARTMENT COVER .
-- Remove the flywheel or drive plate and remove the sensor wheel for the engine speed sensor -G28- from the crankshaft.
-- Remove the cylinder head. Refer to CYLINDER HEAD .
-- Disengage the wiring harness -arrow- and remove the engine speed sensor -1- and vacuum pump -2-.
Fig 1: Identifying Removal Points For Control Housing Cover -1- From Cylinder Block -2- And From Upper Oil Pan -3-
-- Remove the bolts -3-.
-- Pry off the control housing cover -1- from the cylinder block -2- and from the upper oil pan -3- at the positions designated at the top and bottom using a suitable screwdriver -A-.
Fig 2: Identifying Screwdriver And Removal Positions For Control Housing Cover From Cylinder Block Or From Upper Section Of Oil Pan
Start in the area of the alignment sleeves -arrows-.
NOTE:
Make sure the sealing surfaces are not damaged.
-- Drive out the seal with the control housing cover removed.