Toe on front axle, adjusting
If a value lies outside the tolerances, check trim height and balance if necessary.
- Loosen lock nut - 1 -.
- Adjust toe by turning left and/or right tie rod.
To do this position wrench at nut - arrow - on tie rod.
After turning tie rods, ensure that the boots are not twisted.
Twisted boots wear out quickly.
- Tighten lock nut - 1 - 50 Nm and check toe again to ensure adjustment has not changed.
After tightening lock nut - 1 - , it is possible that the adjusted value will change slightly.
If toe adjustment has not moved more than 2' from specification, adjustment is OK.