Checking activation
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Do not touch the Ignition Coil connecting parts or adapter cables during the following test.
- Disable the power supply to the Fuel Injectors N30, N31, N32, N33, by removing Fuse 29 (on fuse panel B) from the fuse holder SB29, in the E-box, plenum chamber.
- Using a diode test lamp , check the Ignition Coil electrical harness connector terminals 1 to 4 and 3 to 4 for voltage.
- Operate the starter.
The LED should flicker.
- Switch the ignition off.
If the LED flickers and the voltage was OK:
- Replace the faulty Ignition Coil N152 .Refer to Ignition/Glow plug, Rep. Group. 28.
If the LED does not flicker: