Engine And Transmission Mount Overview
WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification, refer to one of the following:
Refer to [For transmission(s) 02Q] Specifications .
Refer to [For transmission(s) 02E] Specifications .
- For the transmission mount bracket to the transmission.
- Tightening specification, refer to one of the following:
- Bolt
- 50 Nm + 90° (1/4) additional turn.
Always replace.
- For the pendulum support to the transmission.
- 50 Nm + 90° (1/4) additional turn.
- Engine Mount Bracket
- Bolt
- 40 Nm + 180° (1/2) additional turn.
Always replace.
- For the engine mount bracket to the engine.
- 40 Nm + 180° (1/2) additional turn.
- Engine Mount
- Bolt
- 40 Nm + 90° (1/4) additional turn.
Always replace.
- For the engine mount to the body.
- 40 Nm + 90° (1/4) additional turn.
- Bracket
- Bolt
- 20 Nm + 90° (1/4) turn.
Always replace.
- For the bracket to the body.
- 20 Nm + 90° (1/4) turn.
- Bolt
- 20 Nm + 90° (1/4) additional turn.
Always replace.
- For the bracket to the engine mount.
- 20 Nm + 90° (1/4) additional turn.
- Bolt
- 40 Nm + 90° (1/4) turn.
Always replace.
- For the engine mount to the body.
- 40 Nm + 90° (1/4) turn.
- Bolt
- 60 Nm + 90° (1/4) additional turn.
Always replace.
- For the engine mount to the engine mount bracket.
- 60 Nm + 90° (1/4) additional turn.
- Pendulum Support
- First, secure the pendulum support to the transmission, and then to the subframe.
- Bolt
- 100 Nm + 90° (1/4) additional turn.
Always replace.
- For the pendulum support to the subframe.
- 100 Nm + 90° (1/4) additional turn.
- Bolt
- 60 Nm + 90° (1/4) additional turn.
Always replace.
- For the transmission mount to the transmission mount bracket.
- 60 Nm + 90° (1/4) additional turn.
- Bolt
- 40 Nm + 90° (1/4) additional turn.
Always replace.
- For the transmission mount to the body.
- 40 Nm + 90° (1/4) additional turn.
- Transmission Mount
- The graphic shows the Direct Shift Gearbox (DSG).
- Bolt
- Tightening specification, refer to one of the following:
Refer to [For transmission(s) 02Q] Specifications .
Refer to [For transmission(s) 02E] Specifications .
- For the transmission support to the transmission.
- Tightening specification, refer to one of the following:
- Transmission Mount Bracket