LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2002 >> GTI Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 179 (2.0L - Turbocharger, Supercharger - Engine Code(S): CBEA & CJAA (Sedan) (A5 Platform)) >> 21 Turbocharger, Supercharger >> Specifications >> Fastener Tightening Specifications

Fastener Tightening Specifications

WARNING: This page is about a different car, the 2010 Volkswagen Jetta and 2009 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Component Fastener Size Nm
Brace to Turbocharger Stud Bolt - 20
Charge Air Cooler Mount Bolt - 5
Charge Air Pipe Bolt - 8
Charge Air Pressure Sensor to Charge Air Pipe Bolt - 3
Connecting Hose to Charge Air Pipe Clamp - 5
Connecting Piece to Turbocharger Bolt - 8
Connecting Pipe to Exhaust Manifold Nut (2) - 20
Control Line/Heat Shield to Exhaust Manifold Stud Nut - 23
Damper to Turbocharger Bolt - 10
Exhaust Gas Recirculation Filter to Stud Bolt Nut - 23
Exhaust Gas Temperature Sensor 1 to Exhaust Manifold - 45
Intake Scoop to Turbocharger Bolt - 8
Oil Supply Line Bracket to Turbocharger Bolt - 10
Oil Supply Line to Oil Filter Bracket - 22
Oil Supply Line to Turbocharger - 22
Oil Return Line to Turbocharger Bolt - 15
Particulate Filter to Turbocharger Clamp (1) - 7
Turbocharger Brace to Cylinder Block Banjo Bolt (1) - 60
Turbocharger/Exhaust Manifold to Cylinder Head Nut 1, 2 - 23
Vacuum Actuator with Charge Pressure Actuator Position Sensor to Turbocharger Bolt - 8
Warm Air Collector Plate Bolt - 8
Wiring Harness Bracket Bolt - 8
(1) Always replace
(2) Lubricate the studs for the exhaust manifold with hot bolt pasteG 052 112 A3
scientia non olet · About LEMON Manuals