Leak Detection Pump -V144-
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
Removing
-- Remove the right rear wheel housing liner. Refer to Removal and Installation .
-- Disconnect the vacuum line -2-.
-- Disconnect the connector -3-.
-- Disconnect the vent line -4- by pressing the release button.
-- Remove the cap nuts -1-.
-- Remove the leak detection pump with the bracket.
Installing
Installation is performed in the reverse order of removal. When doing this note the following:
- The vent line -4- must engage audibly.
- Make sure the lines are connected securely.
Tightening Specifications
| Component | Nm | |
|---|---|---|
| Leak detection pump bracket to wheel housing | 9 | |