LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2002 >> GTI Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (2.5L - Fuel Supply - Engine Code(S): BGP, BGQ, CBTA & CBUA (Sedan) (A5 Platform)) >> 20 Fuel Supply >> Diagnosis And Testing >> Fuel Pump, Checking >> Fuel Pump Check Valve, Checking

Fuel Pump Check Valve, Checking

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2008 Volkswagen Jetta, 2007 Volkswagen Jetta, and 2006 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear bench seat. Refer to Removal and Installation .

-- Remove the cover -1- from the fuel delivery unit. The arrow -2- points in the direction of travel.

Fig 1: Removing Cover From Fuel Delivery Unit
GWWM20-0233Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- First, pull on the connector -arrow- without pressing the retainer to make sure it connected securely. If the connector was not connected correctly, it could cause a fault.

Fig 2: Fuel Pump Control Module Connector
GWWN20-10623Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector.

-- Check the contacts on the connector and the fuel delivery unit for damage.

-- Install the test instrument adapter/DSO (5-pin) VAS 5565 between the connectors on the fuel delivery unit and cover.

Fig 3: Connecting Remote Control V.A.G 1348/3A To Test Instrument Adapter/DSO (5-Pin) VAS 5565 And To Battery Plus (+)
GWWN20-10422Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the remote control V.A.G 1348/3A to the test instrument adapter/DSO (5-pin) VAS 5565 and to battery positive (+).

WARNING:

The fuel system is under pressure!

  • Always wear protective eyewear and protective clothing to prevent injuries and fuel from coming in contact with your skin.
  • Before loosening line connections, place a cloth around the connection point. Then release pressure by carefully pulling off the line.

-- Disconnect the fuel supply line -arrow- from the fuel filter.

Fig 4: Fuel Supply Line At Fuel Filter
GWWN20-10629Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the pressure tester VAS 6550 to the fuel supply line using the adapter VAS 6550/1. Hold the other end of adapter VAS 6550/2 in the measuring container.

Fig 5: Connecting Pressure Tester VAS 6550 To Fuel Supply Line Using Hose VAS 6550/1
GWWN20-10632Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Close the shut off lever -A- on the pressure tester VAS 6550 so the lever is perpendicular to the direction of flow.

-- Operate the remote control in short intervals, until a pressure of approximately 4 bar has built up.

WARNING:

Danger of spraying when opening the shut off lever; wear protective goggles and protective clothing to prevent injuries and contact with skin. Hold the container in front of the free connection of the pressure measuring device.

-- If pressure builds up too high, lower the excess pressure by carefully opening the shut off lever.

-- Watch the pressure decrease on the pressure tester.

If the pressure drops further:

-- Check the line connections for leaks.

If no fault is detected in the wiring:

-- The fuel pump is faulty, replace the fuel delivery unit. Refer to FUEL DELIVERY UNIT .