Camshaft Adjustment Valve 1 -N205-

WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Torque Wrench V.A.G 1783
Open End Spanner Insert AF 10 V.A.G 1783/1

Removing

-- Remove the charge air pipe from the noise generator, if equipped. Refer to CHARGE AIR PIPE FROM NOISE GENERATOR .

-- Disconnect the connector -1- from the camshaft adjustment valve 1.

Fig 1: Identifying Camshaft Adjustment Valve And Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -arrows- and remove camshaft adjustment valve 1.

Installing

Install in reverse order of removal. When doing this note the following:

-- Lubricate the seal and O-ring with engine oil.

Tightening specifications, refer to TIMING CHAIN COVERS OVERVIEW .