Checking function

• Connect test box to control module wiring harness, see CONNECT TEST BOX FOR WIRING TEST .
• Re-connect connector at Charge Air Pressure Sensor -G31-.
• Use adapter cables from VAG1594 to connect multimeter to sockets 101 (B+) + 108 (Ground - GND-) for voltage measurement.
• Start engine and measure voltage.

  Specified value: 1.80 to 2.00 volts

• Bring engine to RPM by depressing accelerator pedal suddenly.

Specified value: 2.00 to 3.00 volts

If specified values are not obtained:

• Replace Charge Air Pressure Sensor -G31-, see item  3
• Erase DTC memory of Engine Control Module (ECM), see DIAGNOSTIC MODE 4: RESET/ERASE DIAGNOSTIC DATA .
• Generate readiness code, see READINESS CODE, GENERATING .