Engine code BEV
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2009 Volkswagen Golf, 2008 Volkswagen Golf, 2007 Volkswagen Golf, 2006 Volkswagen Golf, and 2005 Volkswagen Jetta. However, it is still accessible from the selected car via links, so may be relevant.
1 - Cover
2 - Seal
3 - 10 Nm
4 - To intake manifold
5 - Shape hose
- Not for engine code BEV
6 - Shape hose
- Do not separate shape hose/intake hose
7 - To intake manifold
8 - O-ring
- Always replace
9 - Sealing plug-15 Nm
- Always replace
10 - Cylinder head bolt
- Always replace
- Removing and installing Polydrive cylinder head bolt with 3452
- Sequence when loosening and tightening. Refer to Cylinder head, removing and installing , Removing and installing cylinder head
11 - Union
- Coolant hose connection diagram. Refer to Coolant hose connection diagram
12 - 10 Nm
13 - Seal
- Always replace
14 - 20 Nm
15 - Lifting eye
16 - Cylinder head gasket
- Always replace
- After replacement replace complete amount of coolant in system
17 - 15 Nm
18 - 20 Nm
19 - Rear toothed belt guard
20 - Toothed belt
- Mark direction of rotation before removing
- Check for wear
- Do not kink
- Removing, installing and tensioning. Refer to Figure
21 - Cylinder head
- Check for distortion
- Reworking sealing surface. See Figure .
- Removing and installing. Refer to Cylinder head, removing and installing
- After replacement replace complete amount of coolant in system
22 - Oil deflector
23 - Cylinder head cover gasket
- Replace if damaged
- Coat cylinder head/bearing cap transition points with D 454 300 A2 before installing
24 - Cylinder head cover
- With cable guide