Venting Gas-Filled Strut

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

-- Clamp the gas-filled strut in the vise in area -x- x = 50 mm (2 in.).

Fig 1: Identifying Area -x- Of Gas Strut To Clamp In Vise

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

WARNING:

Only clamp the gas strut in area -x-. Otherwise, an accident may occur.

NOTE:

Always wear eye protection when sawing.

Cover the area of the separated portion with a clean rag.

Dispose of the oil and rag properly.

-- Saw into the cylindrical part of strut in the first third of the total cylinder length, determined starting from the edge of the cover on the side with the piston rod.