Vibration Damper Seal, Replacing

WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Thrust Piece T10354
Pulling Hook T20143
Thrust Piece T10368

Removing

-- Remove the vibration damper. Refer to VIBRATION DAMPER .

-- Install the thrust Piece T10368.

Fig 1: Identifying Vibration Damper Bolt And Thrust Piece T10368

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Use the pulling Hook T20143 to remove the seal.

Installing

Tightening specifications, refer to RIBBED BELT OVERVIEW .

-- Clean the running and sealing surface.

-- Remove the thrust Piece T10368.

Fig 2: Identifying Vibration Damper Bolt And Thrust Piece T10368

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pull the seal -arrow- in using the thrust Piece T10354 and the vibration damper bolt.

Fig 3: Identifying Thrust Piece T10354

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Replace the vibration damper bolt and the O-ring -1-.

Fig 4: Identifying O-Ring And Tooth Contour

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Further installation is in the reverse order of removal.