Camshaft Timing Chain Overview
WARNING: This page is about a different car, the 2010 Volkswagen Jetta, 2009 Volkswagen Jetta, 2009 Volkswagen GLI, 2008 Volkswagen Jetta, and 2008 Volkswagen GLI. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension.
- Secure it using the locking pin T40011 before removing.
- Timing Chain Tensioning Rail
- Guide Pin
- 20 Nm
- Bolt
- 9 Nm
- Control Valve
- 35 Nm
- Has left hand threads.
- Remove using the assembly Tool T10352.
- Bolt
- Removing and installing:
M6 bolt:
- 8 Nm + 90° (1/4) additional turn.
M8 bolt:
- 20 Nm + 90° (1/4) additional turn.
- Removing and installing:
- Washer
- Bearing Bracket
- Camshaft Timing Chain Guide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the direction of rotation with paint.
- Removing and installing, refer to CAMSHAFT TIMING CHAIN .
- Camshaft Timing Chain Guide Rail
- Guide Pin
- 20 Nm
- Crankshaft Sprocket
- Note the installed position, refer to Fig 2.
- Both surfaces -arrows- must line up across from each other.