Multi-pin connector with contact assignment: Overview
WARNING: This page is about a different variant/trim than selected.
NOTE:
All contacts not listed are currently not assigned and must never be connected to other components!
Contact assignment of connectors for voltage supply and diagnosis.
| Contact 1 | = | Ground |
| Contact 2 | = | Connection with engine control module (pin 22) |
| Contact 3 | = | Not applicable |
| Contact 4 | = | Not applicable |
| Contact 5 | = | Voltage supply from Battery + through fuse 51 |
| Contact 6 | = | Not applicable |
| Contact | Wiring connection to component... | |
| 1 | Refer to | Ground point |
| 2 | Refer to | Connection with engine control module |
| 3 | Refer to | Not applicable |
| 4 | Refer to | Not applicable |
| 5 | Refer to | Voltage supply from Battery + |
| 6 | Refer to | Not applicable |
Test step overview
| To test component | |||
| Resistance of -V192- brake system vacuum pump |
|
||
| Communication signal of engine control unit to -V192- brake system vacuum pump |
|
||
| Resistance of connection of battery to -V192- brake system vacuum pump |
|
||
| Voltage supply of Battery to -V192- brake system vacuum pump |
|