Brake pedal, removing and installing

Additional information 

Refer to 01 ON BOARD DIAGNOSTIC (OBD)

Removing 

• Remove trim below instrument panel.

Fig 1: Identifying Driver's Side Footwell Trim & Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove screws -1-.
• Remove cover -A-.

Vehicles with manual transmission 

Fig 2: Identifying Connecting Plate Between Clutch And Brake Pedals (Manual Transmission)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Remove connecting plate between clutch and brake pedals on vehicles with a manual transmission.

Continued for all vehicles 

• Remove brake light switch -1-.
• Disconnect accelerator cable.
• Vehicles with accelerator pedal position sensor, release connector below instrument panel.
• Disconnect brake pedal from brake booster. Refer to Brake pedal from brake booster, disconnecting and connecting  .

• Remove hex nuts item - 2 , Brake pedal - assembly overview  .
• Take out pedal cluster.
• Remove brake pedal.

Installing 

Install in reverse order.

• Adjust brake light switch. Refer to Brake light switch, removing and installing/adjusting  .