"Old style" brake light switch, removing and installing/adjusting
WARNING: This page is about a different variant/trim than selected.
NOTE:
The following applies only to an existing, functional "old style" switch that is removed and reinstalled/adjusted.
Removing
- Turn switch counter-clockwise 90.
- Pull switch out from retainer mounting hole.
Installing/adjusting
- Before installing, pull out plunger completely.
- Apply a light coat of lubricant Part No. G 052 142 A2 to end of plunger.
- Depress and hold brake pedal in down position.
- Note orientation of retainer tabs on switch and carefully insert switch into retainer mounting hole
- Secure switch by turning clockwise 90.
- Slowly release brake pedal to stop.
NOTE:
The above action automatically adjusts the switch plunger travel.
- Reconnect electrical connector to switch.
- Check function of brake light switch.