Wheel speed sensor on rear axle (drum brakes), removing and installing

Removing 

• Raise vehicle.

Fig 1: Wheel Speed Sensor And Speed Sensor Wiring Connector & Bolt (Wheel Attached)

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Disconnect wheel speed sensor and speed sensor wiring connector -1-.
• Remove bolt -2- from stub axle.
• Pull ABS wheel speed sensor out of stub axle.

Installing 

• Before inserting speed sensor, clean mounting hole inner surface and coat speed sensor with lubricant G 000 650.
• Insert speed sensor into hole in stub axle and tighten bolt to 8 Nm (70 in. lb).
• Connect speed sensor to speed sensor wiring.