ABS system components on rear axle, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
1 - ABS wheel speed sensor
- Before inserting sensor, clean mounting hole inner surface and coat with lubricant G 000 650
2 - Hex socket head bolt, 8 Nm (70 in lb)
3 - Stub axle
4 - Splash shield
5 - Wheel hub with wheel bearing and speed sensor rotor
- Replace each time after disassembly
- Only replace complete
- Removing and installing
Refer to 42 REAR SUSPENSION
6 - Self-locking 12-point nut, 175 Nm (129 ft. lb)
- Replace each time after removing
7 - Cap
- Pressing off and driving in
Refer to 42 REAR SUSPENSION
8 - Brake disc
9 - Screw
10 - Hex bolt, 60 Nm (44 ft. lb)
- With dished spring
11 - Axle beam