ABS system components for front axle, removing and installing: Notes
WARNING: This page is about a different variant/trim than selected.
NOTE:
Removing and installing ABS system components is identical for FS III and FN 3 brake calipers.
1 - ABS wheel speed sensor
- Before inserting sensor, clean mounting hole inner surface and coat with lubricant, G 000 650
2 - Wheel bearing housing
3 - Hex socket head bolt, 8 Nm (70 in. lb)
4 - Splash shield
5 - Hex bolt, 7 Nm (62 in. lb)
6 - Wheel bearing
- Replace each time after removing
- Removing and installing
Refer to 40 FRONT SUSPENSION
7 - Screw
8 - Brake disc
9 - Wheel hub with ABS wheel speed sensor rotor
- Pressing out and in
Refer to 40 FRONT SUSPENSION
10 - Circlip
Wheel speed sensor for front axle, removing and installing